easystand evolv glider manual

5 Videos on EasyStand Evolv assembly & fitting can be viewed at www.easystand.com FIG. The kneepad does not lock in the upright position when transferring, do NOT grab the kneepad for support. . . . 2- Attach the casters to the rear of the base, lock the casters and hand tighten, do not overtighten. . The Glider accommodates both users needing minimal support and those who require significant positioning to go from sitting to standing. . This will ensure that the EasyStand Evolv is assembled properly and used in the most beneficial manner. . . . Critical areas are padded so the knee pad, seat, back and front pad are always well cushioned. Adjust the handle height to the users desired position and tighten the clamp. . FIG. . . . The Easystand Glider is an active stander that provides reciprocal movement of the arms and legs while standing. . . . . 7 FIG. . . . . Depress the spring button and position the back such that the hip pivot is located as close as possible to the users hips. . Product Compliance with Relevant StandardsEasystand standing frames been tested to and comply with the following standards: Because GTK provides more than just mobility, you will be purchasing the Ultimate Activewear. 13 FIG. 2 Note: Bolts are currently in proper location. . Tighten securely. . glider easystand feature . . . Tighten the ratchet handles after adjusting. Front Column FIG. C, so that the users knee is centered on the kneepad. . Perfect Fit Guide Proper positioning is needed to obtain optimum standing posture. . Tighen knob securely. . B- To flip the table up, move the table to the end of the tube and lift. Option Assembly- Back Option Assembly Back Option Assembly page 11 Option Assembly, Contoured Backs High Contoured Back NG50068 Low Contoured Back NG50062 page 12 Option Assembly, Pump Handles Removable Actuator Handle NG50035 page 13 Option Assembly T-Style Handle Extension NG50070 Quad Grip Handle Extension NG50044, Foot Straps and Airline Buckle Hip Belt Secure Foot Straps NG30031 Standard Foot Straps NG30030 Airline Buckle Hip Belt NG30028 page 14 Option Assembly, Chest Vests and Chest Straps X-Style Chest Vest NG30056 Y-Style Chest Vest NG30021 Chest Strap NG50192-Small NG50193-Large page 15 Option Assembly, Angle Adjustable Tray, Chest Pad and Head Support Angle Adjustable Tray NG50043 not available w/the NG50024 Glider Chest Pad NG30000 not available w/the NG50024 Glider page 16 Option Assembly, Independent Knee and Roho Seat Independent Knee NG50080 not available w/the NG50026 Glider Roho Seat NG30023 page 17 Option Assembly, Universal Lateral Supports Receiver and Lateral Supports Universal Lateral Supports Receiver NG50041 Lateral Supports NG50176 page 18 Option Assembly, Hip Supports and Head Support Head Support NG50037 Hip Supports NG50198 page 19 Option Assembly, Basic Unit Reference Drawing EasyStand Evolv page 20 Reference Drawing-Evolv, EasyStand Evolv Options & Parts Detail page 21 Evolv Options & Parts Detail. 2 Main Frame FIG. FIG. . Tighten the two clamp knobs. FIG. . Unlike passive standers, when using active standers users move the handles with their arms (or a caregiver can assist) which creates a reciprocal movement in the legs. . FIG. 4- Place kneepad onto knee bracket. 11 Basic Unit Reference Drawing-Evolv . Standing programs should be monitored by the attending therapist. Basic Unit Assembly-EasyStand Evolv FIG. 4 FIG. FIG. Active standing technology in the Glider enhances the many health benefits of a passive stander. For Evolv adjustments, see page 23. The Glider combines enhanced lower-body range of motion with upper-body strengthening. 2 Basic Unit Assembly-Evolv . Adjusting Your EasyStand Evolv Footplates FIG. Flip the knee pad down and transition to standing. . 15 FIG. . . . FIG. Slide the front column into the opening of the main frame as shown. 5- Insert the tray post into the front column. 1 FIG. Safety Precautions The EasyStand Evolv (Large) is designed to accommodate most individuals from 5- 6'2" (152cm-188cm) and up to 280 lbs (127kg). Adjusting Your EasyStand Evolv Seat Depth/Back Angle FIG. . . FIG. . . F- Loosen the two clamp knobs located on each of the seat tubes under the seat. . For those that self-transfer, it is a quick lateral transfer into the Glider. . 3 Slide the front column into the opening of the main frame as shown. If you do not meet these specifications and have not been properly fit by a qualified therapist or physician, Altimate Medical Inc. does not recommend that you use the EasyStand Evolv Large. 7- Slide the front Glider column into the opening of the main frame as shown. A 90-day warranty is provided on upholstered components, plastic pads and other components. EasyStand Glider Adjustments FIG. . 3 FIG. FIG. . Caution: Avoid placing fingers in the adjustment slot. 1 FIG. . You may experience a squeaking or a less-than-smooth forward stroke. standing easystand bantam vital 8- Slide the handles into the slots. . Do not tighten securely until all bolts are started. Do not tighten securely until all bolts are started. . . . . The Glider provides lower body range of motion and upper body strengthening. . Tighten securely. For those able to, the Glider. 12 FIG. 1 Safety Precautions . FIG. Place tray onto the tray post, insert nut into slot and tighten securely. 14 FIG. . ROHO seat cushions areavailable for those with pressure management issues. (For easier access to the inside knob, swing the leg assembly forward.) . Additionally, disabilities such as Multiple Sclerosis and ALS are progressive, and positioning options may need to be added over time. Insert bolts and tighten securely. step one (A) (B) (C) (D) (E) (F) (G) (H) Measure client for approximate seat depth (A) and footplate (B) settings. B FIG. . Table of Contents Introduction . Adjust to desired depth and tighten knob. . Configuration Assembly EasyStand Shadow Support Tray FIG. Newly injured and those who have not stood recently often need to acclimate to standing. . A- To adjust the handle height, loosen the clamp. EasyStand Evolv Large Specifications Evolv- Basic Unit Height Range Weight Limit Seat Depth Range -from knee pivot to hip pivot -from knee pivot to back Seat to Footplate Range -from seat pivot Kneepad Depth Range -from seat pivot Seat Height Table/Frontpad Depth Range -from seat pivot Standard Table Height Range -from seat pivot Knee Width Large -center to center Footprint -caster to caster Weight of Basic Unit Frame Color Standard Upholstery Color Standard Table Size Evolv-Shadow Support Tray 50-6. . . . Adjust the foot height FIG. We at Altimate Medical have designed the EasyStand Evolv with your comfort and happiness in mind. A 90-day warranty is provided on upholstered components, plastic pads and other components. . Configuration Assembly- EasyStand Glider FIG. A FIG. . . D FIG. . pow easystand Caution: After flipping up the tray, be certain to tighten the knob. Using the knob located on the following arm, adjust the back angle to vertical +/- 10 degrees. . Altimate Medical, Inc. (AMI) warrants the EasyStand Evolv Large against defects in materials and workmanship as listed below. . . . Do not tighten securely until all bolts are started. . . step two To adjust seat depth, loosen the two ratchet handles under the seat (C). Check your EasyStand periodically to make sure that all nuts, bolts and adjustable parts are tightened securely. 10 FIG. . 9 Option Assembly . . Install the four bolts into the holes. . 11 FIG. . Box 180 262 West 1st St Morton, MN 56270 Toll Free: 800.342.8968 or 507.697.6393 Fax Free: 877.342.8968 or 507.697.6900 email: info@easystand.com www.easystand.com Standing technology should only be used under the guidance of a physician with recommendations for standing program protocol and any medical precautions. Holes in the post must face upward. standing easystand bantam vital So how active will you be today. Afive year warranty is provided on the Easystand steel frames. Tighten the bolts securely. Sit-to-Stand allows a user to stop at any point between sitting and standing. . . B and if necessary, the kneepad mounting position FIG. 8 FIG. The Glider promotes movement of ankles, knees, and hips creating greater range of motion, increased respiration and cardiovascular endurance and weight bearing on the long bones is increased while gliding. A- To adjust the table depth, loosen the knob and lift slightly on the opposite side. . 6 FIG. . 9 FIG. . . . . 8 FIG. . . . FIG. . . FIG. 13 FIG. . Hydraulic Actuator Maintenance An initial break-in period of approximately 50-100 full cycles is normal for the hydraulic unit. Install the four bolts into the holes. A two year warranty is provided on thehydraulic actuator. . A Adjust the height of the foot bracket so the users knee is as close to the knee pivot as possible. B Tighten the clamp securely. 12 FIG. A FIG. To adjust chest pad height, loosen knob and move to desired position. The Gliders modular design helps stand those with the most difficult positioning challenges. . . . . Transferring & Standing Transferring For proper transfer techniques, please seek professional advice from your therapist or physician. . A- Loosen the clamp connecting the foot bracket to the seat post. . 14 FIG. pow easystand Limited Warranty This warranty is extended only to the original purchaser/customer (or supplier non consumer who does not buy or resell). . 5 FIG. . F Do NOT unscrew seat depth knobs all the way when adjusting the seat. FIG. FIG. . This manual is an integral part of your standing system and should be read completely and thoroughly by anyone that will be operating the unit. . 1- Attach the axle weldment to the front column with bolts and tighten securely. . . . . . Maintenance Clean the EasyStand Evolv with a mild non-abrasive disinfectant or soap and water. . 15 FIG. . 2 FIG. . . 11- Install the left table arm rest. Warranty InformationAfive year warranty is provided on the Easystand steel frames. 10 FIG. . glider easystand feature The very close fit of its mating parts gives each pump its own break-in feel and signature sound. Always lock the wheel locks on your wheelchair and the casters on the EasyStand Evolv before transferring. . . Introduction Congratulations on your purchase of the Easystand Evolv standing frame! FIG. The full range seat has hinged, break-away sections for each leg that allow full leg, hip and ankle extension while standing. . The Glider is fantastic for active stretching, cardiovascular training and strength and conditioning. 6- Install the seat onto the main frame. . FIG. . Flip down footplates and insert quick adjust handles. For easier installation, pump the seat halfway up. . For Glider adjustments, see page 25. . FIG. Over 35 different support and positioning components, developed with advice from therapists, can accommodate most positioning challenges. A two year warranty is provided on thehydraulic actuator. EasyStand Shadow Support Tray Adjustments Table Depth Adjustment Chest Pad Adjustment FIG. Install the four bolts into the holes. . . . FIG. . P.O. . . . 3 Configuration Assembly Glider . . . C FIG. B and C- To adjust the foot and knee height, loosen the two knobs shown in B. . 7 Shadow Support Tray . . . Altimate Medical Inc. recommends that you consult with your therapist or physician prior to starting a standing program. . If you do not need assistance in transferring, position your wheelchair next to the EasyStand Evolv. 15 FIG. FIG. The Glider handles allow an attendant to assist in movement, which is especially important for new users. . B- The bracket can also be adjusted plantar/dorsi. 9 FIG. Flip down footplates and insert quick adjust handles. Easystand standing frames been tested to and comply with the following standards: Raz SP Self Propel Tilt Shower Commode Chair. . 9- Attach the axle weldment to the front column with bolts and tighten securely. . . 10- Attach the casters to the rear of the base, lock the casters and hand tighten, do not overtighten. . . . . . . . Depress the snap button on the adjustment tube while moving the back (D). Tighten securely. Adjustable resistance cylinders allow the user to start with minimal resistance and increase as they become stronger. .

Sitemap 19